NEC MD211G3 Guida All'Installazione

To access the OSD menu, press the EXIT button. To change the signal input, press the SELECT button.

All buttons are located at the back of the monitor. 

The Key Guide appears pressing any button when not in the OSD control menu.

The OSD must be closed in order to change the signal input.

1  KEY GUIDE

The Key Guide appears on the screen when the OSD control menu is accessed. 
The Key Guide will rotate when the OSD control menu is rotated.
Perform along the notifi cation of each key.

NOTE: The KEY GUIDE appears as follows:

•  KEY GUIDE when OSD menu is displayed.

 

•  KEY GUIDE when HOT KEY is set to OFF.

 

•  KEY GUIDE when HOT KEY is set to ON.

 

Each KEY GUIDE works as follows:

  - Exits any OSD sub menu.

 

  Exits the OSD Control menu.

  - Shows OSD menu.

  - Shows PICTURE MODE.

  - Selects the item.

  - Changes the input source.

  - Resets the OSD back to factory settings.

  - Shows the quick screen QA test pattern.

2  LED

Indicates that power is on.

3  Control Buttons

A. RESET button
  NOTE: When not in the OSD control menu, press the RESET button for at least 3 seconds  
  to display the quick screen QA test pattern (grayscale) drawing and check the display    
 performance.

B. SELECT  button

C. UP/DOWN  button

D. LEFT/RIGHT  button

E. EXIT  button

4  AMBIENT LIGHT Sensor

Detects the level of ambient light, allowing the monitor to make adjustments to various 
settings. Do not cover this sensor (See page 17).

5  FRONT SENSOR

Detects screen luminance changes over time. 
Used for luminance stabilization, standalone (Self Calibration, Gamma Adjust, DICOM 
Measurement) and network (Gamma Adjutst, DICOM Measurement) controlled calibrations 
and conformance tests.

6  SENSOR PORT

For optional external sensor used for self calibration and copy calibration.