NEC LCD71V Manuale Utente
12
Specifications
Monitor
AccuSync LCD51V
Notes
Specifications
Monitor
LCD Module
Diagonal:
15.0 inch
Active matrix; thin film transistor (TFT)
Viewable Image Size:
15.0 inch
liquid crystal display (LCD); 0.297 mm dot
Native Resolution (Pixel Count):
1024 x 768
pitch; 250cd/m
2
white luminence;
450:1 contrast ratio, typical
Input Signal
Video:
ANALOG 0.7 Vp-p/75 Ohms
Sync:
Separate sync TTL Level (Positive/Negative)
Horizontal sync Positive/Negative
Vertical sync Positive/Negative
Horizontal sync Positive/Negative
Vertical sync Positive/Negative
Display Colors
Analog input:
16,777,216
Depending on display card used.
Maximum
Left/right:
60°/60° (CR>10)
Viewing Angles
Up/Down:
40°/60° (CR>10)
Synchronization
Horizontal:
31.5 kHz to 60 kHz
Automatically
Range
Vertical:
56 Hz to 75 Hz
Automatically
Resolutions Supported
720 x 400*
1
:VGA text
Some systems may not support
640 x 480*
1
at 60 Hz to 75 Hz
all modes listed.
800 x 600*
1
at 56 Hz to 75 Hz
832 x 624*
1
at 75 Hz
1024 x 768 at 60 Hz to 75 Hz .................. NEC-Mitsubishi Electronics Display cites
recommended resolution at 75 Hz for
optimal display performance.
optimal display performance.
Active Display Area
Horizontal :
304.1 mm/12.0 inches
Vertical :
228.1 mm/9.0 inches
Power Supply
100
-240 V
~50/60 Hz
Current Rating
0.45 - 0.25 A
Dimensions
347.4 mm (W) x 341.9 mm (H) x 183.5 mm (D)
13.7 inches (W) x 13.5 inches (H) x 7.2 inches (D)
13.7 inches (W) x 13.5 inches (H) x 7.2 inches (D)
Weight
3.0 kg
6.6 lbs
6.6 lbs
Environmental Considerations
Operating Temperature:
5°C to 35°C/41°F to 95°F
Humidity:
30% to 80%
Feet:
0 to 12,000 Feet
Storage Temperature:
-10°C to 60°C/14°F to 140°F
Humidity:
10% to 85%
Feet:
0 to 40,000 Feet
*
1
Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying nonnative resolutions full screen. In flat panel technologies, each
dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
normal and necessary for all current flat panel technologies when displaying nonnative resolutions full screen. In flat panel technologies, each
dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifications are subject to change without notice.
AS5171Vmanual073003.p65
7/3/03, 3:18 PM
12