Marshall electronic V-R151DP-AFHD Manuale Utente
6
Rear Panel Features
Power Input
Connect the 12VDC input to the Conxall 2-pin twist-lock
power input connector. Power can be supplied from the
included power supply, or from a variety of DC sources
supplying at least 3 Amps at 12 Volts.
power input connector. Power can be supplied from the
included power supply, or from a variety of DC sources
supplying at least 3 Amps at 12 Volts.
IMPORTANT: If using a power source other than the
included power supply, be sure that the polarity of the
DC input is correct:
included power supply, be sure that the polarity of the
DC input is correct:
Pin 1:
+12VDC
Pin 2:
GND
Signal Input/Output
Connections:
•
Composite Video Input/Output (BNC)
•
S-Video Input/Output (4-Pin Mini-DIN)
•
YP
B
P
R
Input/Output (BNC x 3)
•
SDI Input/Output (BNC)
•
VGA (HD-15)
•
DVI (29-Pin connector, DVI-D signals only)
All outputs are active and require the monitor to be
powered.
powered.
Tally Interface
Each tally light is activated via the HD-15 connector by
connecting the corresponding pin to ground. A variety of
external devices can be used to perform the contact
closure. No additional power should be supplied to the
HD-15 port.
connecting the corresponding pin to ground. A variety of
external devices can be used to perform the contact
closure. No additional power should be supplied to the
HD-15 port.
Tally Interface: HD-15 Pinout
Pin No.
Signal
1
Green
2
Red
3
Yellow
4
Ground
5
Ground
6
N/C
7
N/C
8
N/C
9
N/C
10
N/C
11
N/C
12
N/C
13
N/C
14
Ground
15
Ground
Example: To activate the red tally light, connect pin 2 to
pin 4, 5, 14, or 15.
pin 4, 5, 14, or 15.
Mounting Holes
A VESA-standard 75 mm hole pattern is provided to
accommodate a variety of custom mounting options.
accommodate a variety of custom mounting options.
1
2
3
4
1
2
3
4
Rear Panel