Miranda Camera Co M406-9900-402 Manuale Utente

4  |  Kaleido K2 

 

 
Make sure the following items have been shipped with your Kaleido. If any of these are missing, contact your 
distributor or Miranda Technologies Inc. 
 
- Kaleido unit, with pre-installed modules and power supplies 
- 2 AC power cords 
- Kaleido-RCP (remote control panel) 
- RS-422 cable 
- DVI-A-to-VGA (HD-15) adapter 
- red crossover network cable 
- Ethernet jack mounted on a keychain 
- CD-ROM of system software, release notes and a Quick Start manual. 
 
 
 

 
Kaleido may be installed in a standard 19” rack, using the proper screws and washers ( not included). The Kaleido-
RCP Remote Control Panel may also be installed in a rack using the optional mounting kit (order part #1229-1100-
100). 
 
For proper ventilation, make sure the front and rear panel air vents are not blocked and the air filter is clean. 
 
 

3.2.1 Installing Kaleido-RCP in a rack using the mounting bracket. 
 
The Kaleido-RCP is designed to be used on a tabletop; however, a mounting kit is available for installation in a 
standard 19” equipment rack.   
 
Before attaching the Kaleido-RCP to the mounting kit, you will need to move the RS-422 connector. 
-  Remove the 3 screws at the rear of the Kaleido-RCP.   
-  Slightly lift the rear edge of the cover and push on the front edge toward the back of the unit to dislodge the cover 

from the enclosure (figure 3.2.1). 

 

 

 
-  Remove the 2 screws that hold the DE-9S connector to the enclosure.   
-  Pry out the metal plate that covers the DE-9 opening on the bottom of the enclosure. Attach the DE-9S connector 

into this opening (figure 3.2.2). 

-  Re-install the cover on the enclosure.