Seagate ST32430DC Manuale Utente
Hawk 2LP (Wide) Installation Guide, Rev. A 31
continued from previous page
I/O pin 26 to the drive's internal termina-
tors (for single-ended I/O only).
tors (for single-ended I/O only).
Off
See above explanations for TP jump
ers.
ers.
J1-Auxiliary
Jumper
Jumper
Jumper Function Description ("W"
Installation
and "WD" models only)
A
3
,A
2
,A
1
,A
0
Drive ID on SCSI Bus (J1-auxiliary or J6
may be used, as the ID circuits are wired
in parallel). The drive ID is binary coded
positionwise i.e. jumper in position A
in parallel). The drive ID is binary coded
positionwise i.e. jumper in position A
3
is
drive ID 8, A
2
is drive ID 4, position A
1
is
ID 2, position A
0
is ID 1 and no jumpers
is ID 0. Default is ID = 0. Both J1-
auxiliary and J6 should not be used at
the same time, because at some future
time when the ID is changed the user
could fail to configure both J1-auxiliary
and J6 the same. "WC" and "DC" Mod-
els, do not have J1-auxiliary.
auxiliary and J6 should not be used at
the same time, because at some future
time when the ID is changed the user
could fail to configure both J1-auxiliary
and J6 the same. "WC" and "DC" Mod-
els, do not have J1-auxiliary.
J6 Jumper
Jumper Function Description ("W"
Installation
and "WD" models only)
A
3
,A
2
,A
1
,A
0
Drive ID on SCSI bus. Either J6 or J1-
Auxiliary (optional) may be used to
select drive ID. Both should not be used
at the same time, because at some
Auxiliary (optional) may be used to
select drive ID. Both should not be used
at the same time, because at some