Seagate 2160N Manuale Utente
18
Medalist Pro 2160N, Rev. B
termination on all devices between the drive and the device at
the other end of the cable. See “SCSI termination” on page 5.
the other end of the cable. See “SCSI termination” on page 5.
•
Make sure the drive is running. Listen carefully to determine
whether the drive motor is spinning. Also, the drive-activity
LED should flash when the power is turned on. If the LED
stays on after power-on, make sure the interface cable is prop-
erly connected and that no other device on the cable is using
the same SCSI ID.
whether the drive motor is spinning. Also, the drive-activity
LED should flash when the power is turned on. If the LED
stays on after power-on, make sure the interface cable is prop-
erly connected and that no other device on the cable is using
the same SCSI ID.
•
Check the drive type settings in the system setup pro-
gram. The CMOS drive-type must be set to none, zero or not
installed.
gram. The CMOS drive-type must be set to none, zero or not
installed.
•
Verify your SCSI host adapter configuration. Make sure
your host adapter is not using an I/O address or interrupt that
conflicts with other devices in your system. Refer to your host
adapter’s guide for assistance. Host adapters have a diagnos-
tic utility that can help you determine whether such conflicts
exist.
your host adapter is not using an I/O address or interrupt that
conflicts with other devices in your system. Refer to your host
adapter’s guide for assistance. Host adapters have a diagnos-
tic utility that can help you determine whether such conflicts
exist.
•
Check your power-supply specifications. Each time you
add a new device to your computer, make sure your com-
puter’s internal power supply can support the total power
demand. If necessary, consult your dealer for a new power
supply.
add a new device to your computer, make sure your com-
puter’s internal power supply can support the total power
demand. If necessary, consult your dealer for a new power
supply.
•
Check for viruses. Before you use someone else’s diskette in
your system for the first time, scan the diskette for viruses.
your system for the first time, scan the diskette for viruses.
•
Isolate the drive. If there is more than one drive in your sys-
tem, try disconnecting all drives except the new one. Then
configure and install only the new drive. This test helps deter-
mine whether a compatibility problem exists. If you are install-
ing the drive in a network, verify that the drive works with DOS.
tem, try disconnecting all drives except the new one. Then
configure and install only the new drive. This test helps deter-
mine whether a compatibility problem exists. If you are install-
ing the drive in a network, verify that the drive works with DOS.