FieldServer FS-8700-64 Manuale Utente

 

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA  Web:www.fieldserver.com 

Tel: (408) 262-2299   Fax: (408) 262-9042   Toll_Free: 888-509-1970   email: support@fieldserver.com

 

1.  INADEQUATE BYPASS FLOW  0. 
2. EMERGENCY SWITCH 

CLOSURE 

1.TEMP_LOW         
2. TEMP_HIGH         

3. LOSS_OF_NH3_FLOW 

3.  FAILED LEAK CHECK 

0. 

4.  DSP FAILURE in module 

0. 

5.  FAILURE to get interferogram 

1. Bench timeout                     
2. Bench short scan                  
3. Zero ZPD value or address         
4. Bench reports Bad Scan            
5. Bench DREQ stuck TRUE             

6. Energy (ZPD) address out of 

range 

7. energy (ZPD) value too high       
8. energy (ZPD) value too low        

9. DSP reports bad scan 

 

 
The driver stores all gas values after multiplying them by 100. This allows the driver to store 
values in arrays with formats other than floats without losing the precision provided by the ACM 
unit. This is done because some downstream devices’ and protocols cannot handle floating 
point numbers. This may not suite you in which case you will need to use scaling. 
 
These parameter keywords should be added to each CSV Map Descriptor definition. 
 
…..Data_Array_Low_Scale, Data_Array_High_Scale, Device_Low_Scale, 
Device_High_Scale……. 
 
To store the actual values reported by the ACM unit you should use the following values : 
 
…..Data_Array_Low_Scale, Data_Array_High_Scale, Device_Low_Scale, 
Device_High_Scale……. 
…..0                                     , 1                                     , 0                             ,  100….. 
 
 

 
 
The following list are valid entries  in specifying the ATMI_Data parameter in the csv file. 
 
Slot-alarm, 
Slot-warning, 
Slot-combo 
Port-alarm, 
Port-warning, 
Port-combo