Fujitsu MCJ3230AP Manuale Utente
Host Interface
4-68
C156-E205-01EN
Sense Key outlines the error. The definition of Sense Key is listed in Table 4.102.
Table 4.102 Sense Key code
Sense Key
Abbreviation
Definition
0h
NO SENSE
Indicates there is no sense key to be reported. NO
SENSE is set when a command ends normally.
SENSE is set when a command ends normally.
1h
RECOVERED ERROR
Indicates that recovery ends successfully or that the
command ends normally using the internal default value
even if invalid data is detected in command parameters.
(Not reported when the PER bit is 0.)
even if invalid data is detected in command parameters.
(Not reported when the PER bit is 0.)
2h
NOT READY
Indicates that access with an access command cannot be
executed.
3h
MEDIUM ERROR
Indicates that an unrecoverable error is detected due to
media failure.
4h
HARDWARE ERROR
Indicates that an unrecoverable error is detected due to
hardware failure.
5h
ILLEGAL REQUEST
Indicates that command packets or command parameters
contains invalid data. Media data remains unchanged.
6h
UNIT ATTENTION
Indicates that reset, power-on, or media exchange is caused.
7h
DATA PROTECT
Indicates that media is write-protected with the Write
Protect key or the device is softwre-write-protected.
8h
BLANK CHECK
Indicates that a blank sector is detected. Not used
9h-Ah
Reserved
Not used
Bh
ABORTED
COMMAND
COMMAND
Indicates that the command is interrupted.
Ch-Fh
Reserved
Not used
The information indicates LBA of an error block. If an error occurs in multiple
blocks, the LBA of the first block is indicated.
blocks, the LBA of the first block is indicated.
Command-Specific Information indicates the logical track address of the block
indicated in Information (or logical block address). The track address format is
shown in Table 4.103.
indicated in Information (or logical block address). The track address format is
shown in Table 4.103.
Table 4.103 Logical block address format
Byte
Description
8-9
Logical track address
10
00H
11
Logical sector address