HP (Hewlett-Packard) 960i Manuale Utente
17
Step 5: Install the drive
1
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as
shown in Figure 6.
If your server does not use mounting hardware, check that the holes in the chassis are aligned
If your server does not use mounting hardware, check that the holes in the chassis are aligned
with the holes in the side of the tape drive.
Do not secure the drive with screws at this point because you may have to move the drive to
Do not secure the drive with screws at this point because you may have to move the drive to
get the cables into place.
ult960_master_internal.fm Page 17 Tuesday, September 21, 2004 4:13 PM