Fujitsu DX8000 Manuale Utente
Appendix C Syslog Message List
>
>
C.1 Syslog Function
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
823
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
No.
Part name
Field name
Item
Description
1
PRI
Priority
Priority of the message is output in the following for-
mat:
mat:
<Priority>
Priority value indicates the facility and severity of
the message. The Priority value is calculated by
"Facility value x 8 + Severity value".
Facility value for messages is always "1".
Severity values are determined from the following
values according to each message:
the message. The Priority value is calculated by
"Facility value x 8 + Severity value".
Facility value for messages is always "1".
Severity values are determined from the following
values according to each message:
3: Error
4: Warning
6: Informational
4: Warning
6: Informational
HEADER part follows the PRI part.
2
HEADER
Time stamp
The local time when the event is detected is output
in the following format:
in the following format:
Mmm dd hh:mm:ss
Mmm: Abbreviation of each month (Jan
–
Dec)
dd: Date. If the date is a single digit, a blank is out-
put before the date number.
hh:mm:ss: Local time. "hh" indicates the hour (00
put before the date number.
hh:mm:ss: Local time. "hh" indicates the hour (00
–
23), "mm" indicates minutes (00
–
59), and "ss" indi-
cates seconds (00
–
59).
A blank follows the time stamp.
3
Host name
IP Address of the sender port (USER or REMCS) of
the ETERNUS DX400/DX8000 series is output in
the following format:
the ETERNUS DX400/DX8000 series is output in
the following format:
xxx.xxx.xxx.xxx
The IPv4 address is output using the IETF STD13,
RFC 1035 specification.
A blank follows the host name.
RFC 1035 specification.
A blank follows the host name.