Toshiba 6F3A4508 Manuale Utente

TOSHIBA                                                                                         6F3A4508 

 

- 5 - 

 

The necessary information, the creation of setup file based on this information, PC setup, and 
the window display depend on the selected connection method ((1) 1:1, (2) 1:N, or (3) 1:N 
RIO).  
 
Refer to the "Installation manual" (6E3A4507) for details.  
 

4) Connection between PC and drive equipment 
 

The actual connection between the PC and drive equipment is made by an Ethernet cable.  
 
(1) In the case of 1:1 connection, connect the TOOL connector on the drive equipment board 
and the Ethernet connector of the PC with an Ethernet cross cable. The Ethernet cross cable 
is provided with  
W i Tool.  
 
(2) In the case of 1:N, it is not possible to connect to the drive equipment board. Connect the 
Ethernet connector of the PC and the hub with an Ethernet straight cable because the signal 
from the drive equipment is connected to the Ethernet hub.  
 
(3) In the case of 1:N RIO connection, connect the Ethernet connector of the PC and the hub 
with an Ethernet straight cable as with (2) 1:N connection.  
 
Cross cable and straight cable are available as Ethernet cable. Note that the correct cable 
must be used. A single cross cable is included with W i Tool. Straight cables must be 
purchased separately.