Addonics Technologies ADIDEU2 Dépliant
ADDONICS TECHNOLOGIES
Model: ADIDEU2
Installation Guide
Front View
Back View
Note:
It is required to set up the IDE hard drive you are
connecting to the converter as a MASTER device.
connecting to the converter as a MASTER device.
1. Locate the 40-pin IDE connector of your IDE drive.
2. Connect the converter board to the IDE connector of the
hard drive.
3. Using the provided Y-power cable, connect the 4-pin
floppy connector to the power connector of the
converter. This will provide power to the converter.
converter. This will provide power to the converter.
4. At the other end of the Y-power cable is the 4-pin Molex
power connector that you connect to the hard drive.
5. Now connect the B-type USB cable to the USB port on
the converter or use the USB pin header cable.
TECHNICAL SUPPORT
Email:
http://www.addonics.com/sales/query/
Internet:
http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: 408 433-3855
Email:
http://www.addonics.com/support/query/
USB Pin
Header
Header
4-Pin Floppy
Power Connector
Power Connector
40-pin IDE Connector
IDE Connector
4-pin Molex
Power Connector
Power Connector
Master or Slave
Jumper Settings
Jumper Settings
B-Type USB cable
USB Pin Header
cable
cable
B-Type USB
Connector
Connector