National Instruments 321042A-01 Manuale Utente
Chapter 3
Software Installation and Configuration
© National Instruments Corp.
3-3
STD-GPIB for Windows
To run the GPIB software configuration utility, double-click on the GPIB icon in the
Control Panel , which is located in the Main group of the Program Manager .
Control Panel , which is located in the Main group of the Program Manager .
The utility displays a list of all the GPIB modules and device names. Double-click on
any name to examine or edit it. The correct board type to use for the STD-GPIB in the
configuration utility is AT-GPIB/TNT. You can use the online help if you have any
questions. For more information about the GPIB software configuration utility, refer to
the NI-488.2 User Manual for Windows.
any name to examine or edit it. The correct board type to use for the STD-GPIB in the
configuration utility is AT-GPIB/TNT. You can use the online help if you have any
questions. For more information about the GPIB software configuration utility, refer to
the NI-488.2 User Manual for Windows.
If you plan to use the HS488 high-speed protocol, you must specify in the GPIB software
configuration utility the amount of GPIB cable length in your system. The 5 in. GPIB
ribbon cable must be included in the total length.
configuration utility the amount of GPIB cable length in your system. The 5 in. GPIB
ribbon cable must be included in the total length.
After the software is installed and configured, you should verify the installation. Refer to
Chapter 4, Installation Verification and Troubleshooting.
Chapter 4, Installation Verification and Troubleshooting.