NEC 5800/320MA Manuale Utente

 

3-7

3. Physically install the optical Fibre Channel PCI adapters.

For more information about this procedure, including pertinent safety and 
electrostatic discharge precautions for working inside an I/O enclosure, see the 
operation and maintenance guide for your system, as listed 

4. Connect the optical Fibre Channel cables. For more information, see 

.

5. Boot the system. When the operating system loads, it automatically installs a driver 

for the optical Fibre Channel PCI adapters.

6. To ensure that you have the latest approved driver, update the driver for both optical 

Fibre Channel PCI adapters. See 

 for more information.

7. If applicable, install the EMC PowerPath utility on your system and reboot.

8. Configure the storage system and assign storage devices to your system.

For more information about installing the EMC PowerPath utility and configuring the 
storage system, see the documentation set for the storage system.

N O T E

To allow the Optical Fibre Channel PCI adapters for your 
EMC Symmetrix RAID storage system to duplex under 
Express5800/320Ma System Software Release 3.0.0 or 
higher, you must enable the CBIT (Common Serial 
Number) on the Symmetrix director ports connected to 
your system. For further information, contact your EMC 
representative.

Use the following procedure to update the driver for the optical Fibre Channel PCI 
adapters after you physically install the adapters, or anytime the driver needs an 
update.

For information about obtaining the driver, see