Black Box LEH1104A-2SFP Manuale Utente
724-746-5500 | blackbox.com
Page 134
Chapter 7: Command-Line Management
no lacp system-priority
<1-65535> LACP system priority. The default system priority is 32768.
4. Example:
The following example sets the LACP system priority 6700:
switch_a(config)#lacp system-priority 6700
switch_a(config)#
7.7 STP/Ring
Global Configuration, RSTP Port Setting, MSTP Properties, MSTP Instance Setting, MSTP Port Setting, Ring Setting, Chain Setting,
Chain Pass-Through Setting, Advanced Setting
Chain Pass-Through Setting, Advanced Setting
Global Configuration
STP Version:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to choose the Spanning Tree protocol, Rapid Spanning Tree protocol, or Multiple Spanning Tree protocol on a
bridge.
bridge.
3. Command Syntax:
bridge GROUP protocol PROTOCOL vlan-bridge
GROUP <1-1> Bridge group name used for bridging.
PROTOCOL
ieee IEEE 802.1Q spanning-tree protocol.
mstp IEEE 802.1s multiple spanning-tree protocol.
rstp IEEE 802.1w rapid spanning-tree protocol.
4. Example:
The following example chooses the PROTOCOL (rstp) on bridge GROUP (1):
switch_a(config)#bridge 1 protocol rstp vlan-bridge
switch_a(config)#
Multiple Spanning Tree Protocol:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the Multiple Spanning Tree protocol on a bridge.