Transcend Information TS-ABX31 Manuale Utente

•     

When the typematic rate setting is enabled, you can select a typematic rate (the rate at which

character repeats) when you hold down a key of 6, 8, 10,12, 15, 20, 24 or 30 characters per

second.

•     

When the typematic delay setting is enabled, you can select a typematic delay (the delay

before key strokes begin to repeat) of 250, 500, 750 or 1000 milliseconds.

•     

If you have set a password, select whether the password is required while the system boots,

or only when you enter “Setup”.

•     

This function is used to prevent conflict when a MPEG card or some capture cards use the

same palette address. Enable this to make the cards work normally.

•     

Select “OS2” only if you are running OS/2 operating system with greater than 64 MB of RAM

on your system.

•     

S.M.A.R.T. ( Self-Monitoring Analysis and Reporting )

If  your hard disk supports this function, select “Enabled”.

•          

      Select “Yes” to report when there is no floppy disk drive under win95 operating system.

•     

Software that resides in a read-only memory (ROM) chip on a device is called firmware. The

Award BIOS permits shadowing of firmware such as the system BIOS, video BIOS, and

similar operating instructions that come with some expansion peripherals, such as a SCSI

adapter. Shadowing copies firmware from ROM into system RAM, where the CPU can read

it through the 64-bit DRAM bus. Firmware not shadowed must be read by the system through

the 8-bit or 16-bit X-bus. Shadowing improves the performance of the system BIOS and

similar ROM firmware for expansion peripherals, but it also reduces the amount of high

memory (640KB to 1MB) available for loading device drivers, etc. Enable shadowing into