Lindy 70543 Manuale Utente

 

1. Introduction   

This Bridge Board is a converter solution for the Serial ATA Device. It has a standard 
22 pin SATA port which can interface to a Serial ATA device (hard disk, CDROM, 
DVD, CD-RW, etc). It accepts Parallel ATA (IDE) commands through the 40 pin IDE 
connector from the host, decodes the commands and converts them to Serial ATA 
commands to the device. Response from the device through the SATA bus are deciphered, 
processed and converted to parallel ATA protocol and sent to the host. 

The Converter Board supports the Serial ATA Generation 1 transfer rate of 1.5 Gb/s 
(150 MB/s) on the serial ATA side and is compatible with Ultra ATA-133 on the parallel 
ATA side. 

 

   

         Compatible with Ultra ATA 133 specifications 
         Supports all types of SATA storage devices (DVD, DVD-RAM, MO, CD-ROM, 

CD-RW, Hard Disk, ….) 

 
1.1.2. Serial ATA Features   

 Compliant with Serial ATA 1.0 specifications   
 Supports Serial ATA Generation 1 transfer rate of 1.5Gb/s   
 Supports Spread Spectrum in receiver   

 

 

Step 1.    Connect Y-type power cable to J1 connector and PC Power Supply 
Step 2.    Set J3 on M for IDE Master mode or S for IDE Slave mode 
Step 3.    Attaches 22 pin SATA connector (P1) to the back of SATA Device 
Step 4.    Connect IDE cable to J2 (40 pin connector) and IDE Host