Adaptec 2268300R Manuale Utente

Chapter 4: Getting Started

●

44

To replace the full-height bracket with the low-profile bracket:

1

Remove the full-height bracket from the controller board. The full-height bracket is 
installed on the front side of the controller, with the mounting screws inserted from the 
back of the controller, as shown in the Figure 1. Using a Phillips head screw driver, remove 
the mounting screws, as shown in Figure 2, then set the screws aside for use in 

. 

2

Attach the low-profile bracket to the controller board. The low-profile bracket is installed 
on the back side of the controller, with the mounting screws inserted from the front of the 
controller, as shown the Figure 3. 

Insert the screws through the holes on the front of the controller, then fasten the screws to 
the bracket with a Phillips screw driver.

Caution: 

The mount points on the low-profile bracket have a smooth or flat side and a 

raised side that looks like a spacer (see Figure 3). Be sure to install the bracket with 
the flat side against the controller PCB and the raised side facing away from the PCB. 

Caution: 

The torque on the mounting screws should be a maximum of 3.0-4.0 lbf-in to 

avoid deformation. Be sure that the controller is not bent after attaching the low-profile 
bracket to the controller board.

Back of board

Remove mounting 
screws with Phillips 
screw driver

Front of board

Figure 1

Figure 2

Back of board

Front of board

Flat side of bracket

Figure 3

Raised side of bracket