AMD PCM-5820 Manuale Utente
Chapter 2 Installation
25
2.16 VGA interface connections
The PCM-5820 Series board's SVGA interface can facilitates
conventional CRT displays as well as active LCD displays. The
card has two connectors to support these displays, one for standard
CRT VGA monitors and one for flat panel displays.
conventional CRT displays as well as active LCD displays. The
card has two connectors to support these displays, one for standard
CRT VGA monitors and one for flat panel displays.
2.16.1 CRT display connector (CN18)
CN18 is a 15-pin, D-SUB connector commonly used for conven-
tional CRT displays.
tional CRT displays.
Detailed information on pin assignments for CRT display connec-
tor CN18 is given in Appendix A.
tor CN18 is given in Appendix A.
2.16.2 Flat panel display connector (CN12)
CN12 consists of a 44-pin, dual-in-line header.
The power supply (+12 V) for CN12 is dependant on the supply
connected to the board. Therefore make sure that CN9 is connect-
ed to a +12 V power supply.
connected to the board. Therefore make sure that CN9 is connect-
ed to a +12 V power supply.
The PCM-5820 Series provides a bias control signal on CN12
which can be used to control the LCD bias voltage. It is recom-
mended that the LCD bias voltage not be applied to the panel until
the logic supply voltage (+5 V or +3.3 V) and panel video signals
are stable. Under normal operation the control signal (ENAVEE)
is active high. When the PCM-5820 Series board's power is
applied, the control signal is low until just after the relevant flat
panel signals are present.
which can be used to control the LCD bias voltage. It is recom-
mended that the LCD bias voltage not be applied to the panel until
the logic supply voltage (+5 V or +3.3 V) and panel video signals
are stable. Under normal operation the control signal (ENAVEE)
is active high. When the PCM-5820 Series board's power is
applied, the control signal is low until just after the relevant flat
panel signals are present.