Ampro Corporation 420 Manuale Utente
Chapter 1
Setting Up the CoreModule 420
8
QuickStart Guide
CoreModule 420
• Connect the AT power supply (or +5 voltage power supply) to
the power connector on J7 of the CoreModule.
13) Connect all support devices
to the power supply
• Ensure all of the support devices you have plugged into the
connectors from the CoreModule have good power connections
to the AT power supply.
to the AT power supply.
Applying Power to the CoreModule 420
14) Check/Set the Power Supply
Input Voltage
• If the power supply module uses auto-ranging operation at
50/60Hz, skip this step.
• Check the input voltage switch on the power supply located on
the rear of the supply just below the power connector.
The input voltage switch typically has two positions: 115 or 230
volts – 115 volts is default position.
volts – 115 volts is default position.
15) Check jumpers on the board
• Check the jumpers on the CoreModule 420 before applying
power to the board. Refer to Figure 1-2 and the Table 1-1 at the
end of this chapter.
end of this chapter.
CAUTION
To prevent damage to the CoreModule 420, check
the jumper settings before applying power to the
board. The jumpers could be loose or missing due to
shipping.
the jumper settings before applying power to the
board. The jumpers could be loose or missing due to
shipping.
16) Power up the
CoreModule 420.
CoreModule 420.
•
Plug the CRT monitor’s power cord into an AC outlet and turn
on the monitor.
•
Plug the AT power supply’s power cord into the AC outlet.
•
Turn the AT power supply’s power switch to On before
continuing.
17) Verify the
CoreModule 420
powers-up satisfactorily.
CoreModule 420
powers-up satisfactorily.
• You should see POST complete successfully before the system
starts loading the operating system.
•
If the operating system (OS) is found, exit the OS and reboot the
system to set the initial BIOS Setup options. Go to Step 16.
If the desired OS is not loaded on one of the boot devices (floppy
drive, CompactFlash (CF), or CD-ROM) prior to power up, you
will see an error message “No Bootable Device Available” after the
CoreModule 420 completes the boot process. The boot process
stops until you to select from one of these options:
drive, CompactFlash (CF), or CD-ROM) prior to power up, you
will see an error message “No Bootable Device Available” after the
CoreModule 420 completes the boot process. The boot process
stops until you to select from one of these options:
♦
Enter BIOS Setup – press S or skip to Step 18.
S – for entering BIOS Setup
♦
Press R to reboot the system.
R – for Rebooting the system
♦
Load a bootable device with the Operating System
included, press R to reboot, and then skip to Step 18.
included, press R to reboot, and then skip to Step 18.
♦
Turn off the power switch on the power supply.
• If you do not make a selection, the POST routine remains stalled,
until you intervene.