Dakota Digital CLK-1002B Manuale Utente

 

 

 
Introduction: 

The Odyssey gauge series from Dakota Digital, Inc. incorporates the reliability and quality of our 

standard gauges, along with several unique features and easy mounting.  These features include:   
• Quartz 

accuracy. 

•  Night dimming feature. 
•  Very low standby power to prevent battery drain. 
•  High Visibility VFD display for sunlight readability. 

 
The Odyssey series clock displays the current time in 12 hour format.  The high brightness display 

matches our other Odyssey and STR series gauges and has the same night brightness dimming capability. 

 

The gauge needs the red, orange, and black wires connected to operate.  The red wire should have 

switched 12 volt power from an ACC. point on the fuse panel.  The orange wire should have constant 12 volt 
power.  The black wire should be connected to a good ground point.  When the blue wire has 12 volts, it will dim 
the display for night viewing. 
 
Setting the time: 

Using a small, thin object such as a toothpick or pin, press “set” buttons through front lens access holes.  

The access holes are on the right side of the lens.  Top “set” button advances hours, bottom “set” button 
advances minutes.  Each time that you make a change to either the hours or minutes, the seconds are reset to 
zero.   

 

The clock is accurate to +/-2 minutes a month as it is sent.  It can be tuned for better accuracy if 

desired.  Press and hold both of the set buttons for several seconds.  The clock will display “C  0”.  The “C” 
indicates that it is in the calibration mode and the second number is the current calibration value.  The 
calibration value indicates the number of seconds to add or subtract each day.  The clock can be adjusted from 
+7 sec/day to -7 sec/day. 
Press the minute set button to change the cal value.  Press the hour set button to return to normal clock 
operation.