Acu-Rite CNC 3500i Manuale Utente
202
7 Programming: Canned Cycles, sub-programs
7.
3 Pr
obing Cy
cles
Field
Code
Description
Tool#
T
Tool number. (Required)
With only the T cycle parameter present,
the canned cycle does not step over half
the tool's diameter but comes straight
down measuring the tool length and storing
it in the tool register.
With only the T cycle parameter present,
the canned cycle does not step over half
the tool's diameter but comes straight
down measuring the tool length and storing
it in the tool register.
EstDiam
D
This is the rough diameter of the tool. This
should be within 0.04" (1.0 mm). (Optional)
If the D cycle parameter is present, the tool
steps over half of its diameter, the spindle
turns on in reverse and then the canned
cycle measures the tool's length.
A negative D value is for a left-handed tool
and causes the spindle to come on forward
instead of reverse.
For on center length measurement, do not
give a D cycle parameter.
should be within 0.04" (1.0 mm). (Optional)
If the D cycle parameter is present, the tool
steps over half of its diameter, the spindle
turns on in reverse and then the canned
cycle measures the tool's length.
A negative D value is for a left-handed tool
and causes the spindle to come on forward
instead of reverse.
For on center length measurement, do not
give a D cycle parameter.
MeasType
Q
This option specifies to measure length,
diameter, or both and the appropriate tool
registers are updated. (Optional)
[Default: Q1]
Q0 Measure the diameter only
Q1 Measure the length only
Q2 Measure both length and diameter
If Q is not set, the cycle measures the tool
length only.
If Q0 or Q2 are programmed, you must also
have a D cycle parameter or the control
displays an error message.
diameter, or both and the appropriate tool
registers are updated. (Optional)
[Default: Q1]
Q0 Measure the diameter only
Q1 Measure the length only
Q2 Measure both length and diameter
If Q is not set, the cycle measures the tool
length only.
If Q0 or Q2 are programmed, you must also
have a D cycle parameter or the control
displays an error message.