Casio KL-G2 Manuale Utente

EN

A tape cartridge is required when printing tape labels. You should use only the 
special tape cartridges that are specifi ed for this printer.
•  This printer supports the following tape widths: 6mm (

1

/

4

"), 9mm (

3

/

8

"), 

12mm (

1

/

2

"), 18mm (

3

/

4

"), 24mm (1").

Press OFF to turn off the printer.

Press the tape compartment cover open button and open the cover.

Remove the stopper attached to the tape cartridge.

Stopper

Check the condition of the tape and the ink ribbon.
•  Make sure the leading end of the tape is not bent. If it is, use scissors 

to trim off the bent part.

•  Make sure the leading end of the tape is passing through the tape 

guide.

•  Make sure there is no slack in the ink ribbon.

Tape (Pull out about 
3cm (1 

3

/

16

").)

Ink ribbon 
(under the tape)

Tape guide

Important!
•  Tape once pulled out of the cartridge cannot be pushed back in.

•  Do not apply excessive force when pulling on the tape. Doing so can break 

or otherwise damage the ink ribbon.

•  Loading the tape cartridge into the printer while the ink ribbon is slack can 

cause the ink ribbon to break, creating the risk of malfunction.

a

b

If there is slack in the ink ribbon, insert a pencil or similar object into 
the upper right spindle (a in the nearby illustration) and rotate in the 
direction indicated by the arrow. Rotate until the lower left spindle (b in the 
illustration) starts to rotate. Note that the tape will not move along with the 
ink ribbon at this time.