Casio KL-G2 Manuale Utente

EN

When the screen shown above is on the display, select EXIT and then 
press SET twice.
•  This returns to the screen shown below.

Important!
•  Never turn off printer power while printing is in progress.

•  Never open the tape compartment cover while printing is in progress. 

(page 12) 

•  Do not touch the tape coming out of the printer until it is automatically cut or 

until printing is complete.

•  Avoid allowing tape cuttings to pile up around the printer tape outlet. 

Tape cuttings around the tape outlet creates the risk of tap jamming and 
malfunction.

When printing multiple labels during a single print operation, you can 
confi gure printer settings that control whether or not there should be an 
automatic cut between each of them. Depending on the type of tape you are 
printing, use of the cutter can cause cutter wear and malfunction.
•  The tape types in the table below are special tape. Make sure you use 

FULL CUT or UNCUT whenever printing on special tape.

•  Iron-on transfer tape

•  Magnetic tape

•  Refl ective tape

•  Iron-on fabric tape

 

■ Cutting Types

The printer can perform two types of cutting.

•  HALF CUT

HALF CUT cuts only the sticker part of 
the tape, but leaves the backing paper 
intact. This means you can peel labels 
from the backing paper as you need 
them.

•  FULL CUT

FULL CUT cuts both the sticker part 
and the backing paper of the tape.

Full cut

Half cut

Half cut

S ales

Sales