Xerox PE220 Manuale Utente
9
Troubleshooting
9-10
Xerox PE220
Memory Full
The memory is full.
Delete unnecessary documents
and retransmit after more
memory becomes available.
Alternatively, split the
transmission into more than one
operation.
and retransmit after more
memory becomes available.
Alternatively, split the
transmission into more than one
operation.
No Answer
The receiving fax
machine has not
answered after several
redial attempts.
machine has not
answered after several
redial attempts.
Try again. Make sure that the
receiving machine is
operational.
receiving machine is
operational.
No Cartridge
Detected
Detected
The print cartridge is
not installed.
not installed.
Install the print cartridge. See
.
Not Assigned
The speed dial location
you tried to use has no
number assigned to it.
you tried to use has no
number assigned to it.
The ID you entered is
not assigned.
not assigned.
Enter the correct ID. .
No Paper
Add Paper
Add Paper
The paper in the tray
has run out.
has run out.
Load paper in the tray. See
Operation
Not Assigned
Not Assigned
You are doing the Add/
Cancel operation, but
there are no jobs
waiting.
Cancel operation, but
there are no jobs
waiting.
Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
Out of Range
The current date and
time you entered is not
correct.
time you entered is not
correct.
Enter the correct date and time.
Open Front Door
Remove Paper
Remove Paper
Paper has jammed in
the feeding area of the
tray
Paper has jammed in
the fuser area or around
the print cartridge.
the feeding area of the
tray
Paper has jammed in
the fuser area or around
the print cartridge.
Clear the jam. See
.
Clear the jam. See
.
Open Rear Cover
Remove paper
Remove paper
Paper has jammed in
the paper exit area.
the paper exit area.
Clear the jam. See
Power Failure
Power has turned off
then on and the
machine’s memory has
not been saved.
then on and the
machine’s memory has
not been saved.
The job which you were trying to
do before the power failure
must be completely re-done.
do before the power failure
must be completely re-done.
Display
Meaning
Suggested Solutions