Toshiba GD-1220 Manuale Utente

52    Specifying the Remote Fax

The original is scanned into memory and automatically starts to be sent once a connection has 
been made.

y

The default setting is memory TX, however you can set direct TX as the default, To change 
the default setting from memory TX to direct TX, see   P.184 “Memory transmission”.

y

Even if the memory TX mode is selected as the default, you can use the [DIRECT TX] key to 
perform direct TX temporarily. For details of temporary direct TX, see   P.87 “Direct trans-
mission”.

y

- You can send the original even while memory TX, receiving a Fax document or printing 

report/list is being performed.

- When the remote Fax line is available, the equipment begins dialing after the first page is 

scanned to memory.

- If the original cannot be sent (the remote Fax is busy or otherwise unavailable), the 

remote Fax is automatically redialed repeatedly.

y

- When the amount of memory remaining for memory TX usage reaches 0, the original is 

automatically transmitted in the direct transmission mode.

- Up to 100 transmissions can be reserved.

y

- ECM (Error Correction Mode) is an internationally standardized communication mode 

that automatically corrects errors that occur during Fax transmissions.

y

- The equipment assigns a File Number to each transmission or polling-reception job for 

internal control of reserved communications. This File Number is very useful, should it 
become necessary to cancel a memory operation. It is also useful when tracking commu-
nication activities using the transmission and reception journals.

- The amount of memory remaining for memory TX usage is called Residual Memory and 

is displayed as a percentage value.

- If there is not enough residual memory, a Memory Full status may occur.

When this status occurs, the scanned document data is cleared (default setting). Press-
ing the [FUNCTION CLEAR] button returns to the basic screen.

y

If a Group Dialing number is not 
programmed, the message 
"Number not listed" is displayed 
for 2 seconds and the display 
returns to the previous status 
screen.

y

The screen on the right may 
appear when the equipment has 
failed to detect the original size. 
In this case, re-place the origi-
nal, or select the original size 
using the 

 or 

 button 

and press the [ENTER] button.

TELEPHONE NUMBERS LIST

Number not listed

GROUP NUMBER:          0088

Select original size

2.LD

3.LT-R

1.LT