Toshiba GD-1220 Manuale Utente
2 BASIC FUNCTIONS
52 Specifying the Remote Fax
Memory Transmission
The original is scanned into memory and automatically starts to be sent once a connection has
been made.
been made.
y
The default setting is memory TX, however you can set direct TX as the default, To change
the default setting from memory TX to direct TX, see P.184 “Memory transmission”.
the default setting from memory TX to direct TX, see P.184 “Memory transmission”.
y
Even if the memory TX mode is selected as the default, you can use the [DIRECT TX] key to
perform direct TX temporarily. For details of temporary direct TX, see P.87 “Direct trans-
mission”.
perform direct TX temporarily. For details of temporary direct TX, see P.87 “Direct trans-
mission”.
y
You can send the original whenever the standby mode screen is displayed.
- You can send the original even while memory TX, receiving a Fax document or printing
report/list is being performed.
- When the remote Fax line is available, the equipment begins dialing after the first page is
scanned to memory.
- If the original cannot be sent (the remote Fax is busy or otherwise unavailable), the
remote Fax is automatically redialed repeatedly.
y
Originals are scanned at high speed and stored to memory, therefore you can return
originals to their files immediately.
originals to their files immediately.
- When the amount of memory remaining for memory TX usage reaches 0, the original is
automatically transmitted in the direct transmission mode.
- Up to 100 transmissions can be reserved.
y
Page on which error occurred is automatically transmitted again. (ECM function)
- ECM (Error Correction Mode) is an internationally standardized communication mode
that automatically corrects errors that occur during Fax transmissions.
y
File Number and Residual Memory
- The equipment assigns a File Number to each transmission or polling-reception job for
internal control of reserved communications. This File Number is very useful, should it
become necessary to cancel a memory operation. It is also useful when tracking commu-
nication activities using the transmission and reception journals.
become necessary to cancel a memory operation. It is also useful when tracking commu-
nication activities using the transmission and reception journals.
- The amount of memory remaining for memory TX usage is called Residual Memory and
is displayed as a percentage value.
- If there is not enough residual memory, a Memory Full status may occur.
When this status occurs, the scanned document data is cleared (default setting). Press-
ing the [FUNCTION CLEAR] button returns to the basic screen.
ing the [FUNCTION CLEAR] button returns to the basic screen.
y
If a Group Dialing number is not
programmed, the message
"Number not listed" is displayed
for 2 seconds and the display
returns to the previous status
screen.
programmed, the message
"Number not listed" is displayed
for 2 seconds and the display
returns to the previous status
screen.
y
The screen on the right may
appear when the equipment has
failed to detect the original size.
In this case, re-place the origi-
nal, or select the original size
using the
appear when the equipment has
failed to detect the original size.
In this case, re-place the origi-
nal, or select the original size
using the
or
button
and press the [ENTER] button.
TELEPHONE NUMBERS LIST
Number not listed
GROUP NUMBER: 0088
Select original size
2.LD
3.LT-R
1.LT