Brother FAX-222 Manuale Utente

      L O C A T I O N   A N D   C O N N E C T I O N S

The external TAD must be plugged into the back of the fax machine, into the jack 
labeled EXT. Your fax machine cannot work properly if you plug the TAD into a wall 
jack.

Plug the telephone line cord from the wall jack into the left side of the fax machine, in 
the jack labeled LINE.

Plug the telephone line cord from your TAD into the left side of the fax machine, in 
the jack labeled EXT. (Make sure this cord is connected to the TAD at the TAD’s 
telephone line jack (not to telephone set jack).)

Set your external TAD to four rings or less. (The fax machine’s Ring Delay setting 
does not apply.)

Record the outgoing message (see below).

Set the TAD to answer calls.

See Message Storage (

, 

, 

) to VOICE:EXT. (For FAX-333MC only)

Set the Answer Mode to MC:MSG CTR. (For FAX-333MC only)
On the FAX-202 or FAX-222, set the Answer Mode to TAD:ANSWER MACH.

Timing is important in recording this message. The message sets up the ways to handle 
both manual and automatic fax reception.

Record 5 seconds of silence at the beginning of your message. (This allows your fax 
machine time to listen for the fax CNG tones of automatic transmissions before they 
stop.)

Limit your speaking to 20 seconds.

End your 20-second message by giving your Fax Receive Code for people sending 
manual faxes. For example: 
“After the beep, leave a message or send a fax by pressing 

 5 1 and Start.”

Your fax machine is equipped with a handset that you can use as a regular phone. 
However, you can also connect a separate telephone (or telephone answering device) 
directly to your fax machine.

Connect the modular plug on the telephone’s line cord to the jack labeled EXT. on the 
back of the fax machine. 

Whenever this phone (or TAD) is in use, the screen displays EXT. TEL IN USE, and, 
if the fax machine handset is lifted, an alarm sounds. To disconnect the call and switch 
to the fax machine, press 

or 

.