Barco 26-0503000-00 Manuale Utente

Using the Grouping Tab

To check the “members” of a group, click a group in the Group column.  All 
assigned group input and output buttons will light in yellow.  If no buttons light, that 
group is not configured. 

„

Use the following steps to create an input/output group:  

1.  In the Group column, click the radio button for the group that you wish to create.

2.  In the Output column, click the button(s) for the output(s) that you want to be in 

the group.  Each selected output button turns yellow.

3.  In the Input column, click the button(s) for the input(s) that you want to be in the 

group.  Each selected input button turns yellow.

4.  Repeat from step 1 to configure additional groups.  Note that once an input or 

output is included in a group, it is grayed out.

„

Use the following steps to add an input or output to an existing group:  

1.  In the Group column, click the radio button for the group that you want to modify.

2.  In the Output column, click the button(s) for the output(s) that you want to add to 

the group.  Each selected button turns yellow.  

3.  In the Input column, click the button(s) for the input(s) that you want to add to the 

group.  Each selected button turns yellow.  

4.  Repeat from step 1 to add inputs or outputs to additional groups.  

„

Use the following steps to remove an input or output from an existing group:  

1.  In the Group column, click the radio button for the group that you want to modify.

2.  In the Output column, click the button(s) for the output(s) that you want to remove 

from the group.  Each selected button turns off.  

3.  In the Input column, click the button(s) for the input(s) that you want to remove 

from the group.  Each selected button turns off.  

4.  Repeat from step 1 to remove inputs or outputs from additional groups.  

„

Use the following steps to completely remove (clear) an existing group:  

1.  In the Group column, click the radio button for the group that you want to remove.

2.  Click Remove Group.

„

Use the following steps to remove all groups:  

1.  Click Remove All Group.

Grouping of inputs and outputs does not establish a route.  
The input source for a particular output still must be 
established using the standard “take” procedure on the Video 
Switching Tab.