ICP DAS USA SST-2450 Manuale Utente
SST-2450 Wireless Modem User’s Manual
Ver1.5
, Feb /2003, OMH-030-10,
---18
1. Select a COM port from which your SST-2450 is connected to the PC. In
the setting mode, the baud rate must be set at 9600bps and the Line
control values must be N, 8,1. Click the “Open” button to open a
connection to the device then click the “Setting SST-2400” button to
continue.
control values must be N, 8,1. Click the “Open” button to open a
connection to the device then click the “Setting SST-2400” button to
continue.
2. The following screen will appear. From the options shown in the
Interface & Mode status panel, choose a suitable operational mode for
your system. After making your selections, click the “Set” button. Repeat
this procedure for Set Baud rate & Data Format, Set P/N code and Set
Channel, making sure you click the “Set” button each time, otherwise
the amended values will be lost. Click the “Save & Exit” to close the
setting screen. All settings not saved will be lost. Click the “Save & Exit”
button to save the new setting values.
your system. After making your selections, click the “Set” button. Repeat
this procedure for Set Baud rate & Data Format, Set P/N code and Set
Channel, making sure you click the “Set” button each time, otherwise
the amended values will be lost. Click the “Save & Exit” to close the
setting screen. All settings not saved will be lost. Click the “Save & Exit”
button to save the new setting values.
1
2
3
1
2