Pinnacle PCTV SAT CI PCI DVB-S DE EN NL Ret +rem 202261451 Manuale Utente
Codici prodotto
202261451
Appendix A: Tips & Tricks
VII
S
ETTINGS IN
W
INDOWS
2000
AND
W
INDOWS
XP
The system applet of the Windows 2000/Windows XP Control Panel
contains several options you can enable or disable for optimal capture
performance. During capturing the drive should write as much data as
possible and not spend time with software optimisations or checking for
system changes.
contains several options you can enable or disable for optimal capture
performance. During capturing the drive should write as much data as
possible and not spend time with software optimisations or checking for
system changes.
To access these options in Windows, click the Start menu. Under Settings
click Control Panel, and double-click the System applet. In the window
System Properties you can make the desired settings.
click Control Panel, and double-click the System applet. In the window
System Properties you can make the desired settings.
Click on the Hardware tab, then on the Device Manager... button
under Device Manager:
In the list under IDE ATA/ATAPI Controller first click on Primary IDE
Channel using the right mouse button and choose Properties from the
context menu. Then go to the Further Settings tab.
In the list under IDE ATA/ATAPI Controller first click on Primary IDE
Channel using the right mouse button and choose Properties from the
context menu. Then go to the Further Settings tab.
If two devices are shown, carry out the following settings for both devices.
Pay attention to what appears in the Current transmission mode box at
the bottom. If Ultra DMA mode is displayed, the correct setting is
already active and you do not need to make any changes.
If this is not the case, choose the DMA, if available setting from the
Transmission mode list box. Ultra DMA mode will then appear after the
computer has been restarted.
the bottom. If Ultra DMA mode is displayed, the correct setting is
already active and you do not need to make any changes.
If this is not the case, choose the DMA, if available setting from the
Transmission mode list box. Ultra DMA mode will then appear after the
computer has been restarted.
Confirm with OK.
Now click on Secondary IDE channel in the list with the right mouse
button and carry out the same settings as for the primary IDE channel.
button and carry out the same settings as for the primary IDE channel.
You will have to restart your machine now for the new settings to take
effect.
effect.