Dynalink RTA770 Manuale Utente

Default Configuration for Australia
This router is shipped with the following factory default settings.
Router IP address
Router IP address
192.168.1.1
Subnet mask
255.255.255.0
VPI
8
VCI
35
Connect mode
PPPoA VC-MUX
NAT
enabled
DSL line mode
auto select G.DMT / T1.413
WAN IP
dynamic
DHCP
enabled
DNS relay
on
UPnP IGD
enabled
Firewall incoming
on
Firewall outgoing
off
Router configuration & management:
User name
User name
admin
Password
admin
Telnet password
admin
If your ISP specifies that your ADSL service is PPPoE, connect mode must be
changed to PPPoE LLC/SNAP. Instructions will follow. Check with your ISP if
you are unsure of the type of service you have subscribed to. Advanced users
who have other setup preferences should first read the User’s Manual.
changed to PPPoE LLC/SNAP. Instructions will follow. Check with your ISP if
you are unsure of the type of service you have subscribed to. Advanced users
who have other setup preferences should first read the User’s Manual.
Before you start
Make sure your computer has these installed:
Ethernet or USB port
TCP/IP protocol enabled
A web browser, Internet Explorer 5.0/Netscape 6 or better.
TCP/IP protocol enabled
A web browser, Internet Explorer 5.0/Netscape 6 or better.
Obtain your Internet account information from your ISP:
Login user name and password
Public IP address (only if you subscribe for static IP)
DNS server IP (only if specified by ISP).
Public IP address (only if you subscribe for static IP)
DNS server IP (only if specified by ISP).
1
2