Olympus DM-4 Manuale Utente

Pagina di 185
1
EN
Power supply
1
 While  pushing  down  on  the
grooves using both thumbs, slide
the battery cover in the direction
indicated by the arrow.
Inserting the battery
This recorder uses a lithium ion battery 
specified by Olympus (LI-50B). Do not use 
any other type of battery.
2
 With the back label of the battery
facing up, line up the terminals of
the recorder and battery. Insert the
battery by sliding in direction A
while pushing down in direction B.
3
 Close the battery cover by sliding
all the way in direction B while
pushing down in direction A.
•  Be careful of the direction of the 
battery when inserting it.
•  The  supplied  rechargeable  battery 
is not fully charged. Before using the 
unit the first time or after long periods 
of disuse, it is recommended that you 
charge it until full (☞ P.23).
  Notes
•  Be sure to stop the recorder before replacing 
the battery. Unloading the battery while the 
recorder is in use may corrupt the file.
•  The battery cover is not attached at the 
time of purchase.
•  Do not use too much force when inserting 
the  battery.  Use  only  the  method  listed 
above  to  install  and  remove  the  battery. 
Otherwise, damage may occur.
•  If it takes longer than 15 minute to replace 
the dead battery or if you take the battery 
in and out repeatedly at short intervals, you 
may have to reset the time when you have 
loaded fresh batteries (☞ P.29).
•  Remove the battery if you are not going to 
use the recorder for an extended period of 
time.
Po
w
er s
up
ply