ONKYO ABX-N300 Manuale Utente
En-
23
Setting the Clock
(remote controller only)
1
While the ABX-N300 is in standby mode,
press the [TIMER] button.
press the [TIMER] button.
If the ABX-N300 is powered-on, press the []
button to enter standby mode.
button to enter standby mode.
2
Use the []/[] buttons to select “Clock
Setup.”
Setup.”
3
Press the [ENTER] button.
4
Use the []/[] buttons to set the time, and
press the [ENTER] button.
press the [ENTER] button.
If you hold down the []/[] buttons, the value
will change continuously.
will change continuously.
To switch between 12-hour and 24-hour display,
press the [DISPLAY] button.
press the [DISPLAY] button.
5
Use the []/[] buttons to set the “day of the
week.”
week.”
6
Press the [ENTER] button.
The setting will be completed, and then the display
will return to the standby condition.
will return to the standby condition.
Cancelling without setting the time
Press the [TIMER] button.
Press the [TIMER] button.
Returning to the previous screen
Press the [] button.
Press the [] button.
Caution
If the power supply is interrupted by a power failure or
by disconnecting the AC adapter, “--:--” will be
displayed, and the clock will stop. If this occurs, set the
clock again.
by disconnecting the AC adapter, “--:--” will be
displayed, and the clock will stop. If this occurs, set the
clock again.
If you press the [DISPLAY] button while in standby
mode, the clock and day of the week will be shown for
approximately eight seconds.
mode, the clock and day of the week will be shown for
approximately eight seconds.
ENTER
TIMER
F/H
O
DISPLAY
M
Setting the Time and Day of the Week
Timer1 Setup
Timer2 Setup
Clock Setup
Clock Setup
10:15
Sunday
Displaying the Clock