Manualsbrain.com
  1. Manuali
  2. Marche
  3. Panasonic
  4. CF-31
  5. Manuale Utente

Panasonic CF-31 Manuale Utente

Scarica
Pagina di 40
25
Troubleshooting
 Display
No display.
  The external display is selected. Press 
Fn
 + 
F3
 or 
 + 
P
 to switch the display. Wait 
until the display has been switched completely before pressing 
Fn
 + 
F3
 or 
 + 
P
again.
  When using an external display,
  Check the cable connection.
  Turn on the display.
  Check the settings of external display.
  The display is turned off by the power-saving function. To resume, do not press the 
direct selection keys, but press any other key like 
Ctrl
.
  The computer entered sleep or hibernation by the power-saving function. To resume, 
press the power switch.
The screen is dark.
  The screen is darker when the AC adaptor is not connected. Press 
Fn
 + 
F2
 and adjust 
the brightness. As you increase the brightness, battery consumption increases.
  You can separately set the brightness for when the AC adaptor is connected and when 
not connected.
 Press
 
Fn
 
+
 
F8
 
to turn off the concealed mode.
The screen does not be-
come bright even if pressing 
Fn
 + 
F2.
  The brightness is set low to avoid malfunction where surrounding temperature is high. 
Use it in an environment of between -10 °C and 50 °C {14 °F to 122 °F}.
The screen is disordered.
  Changing the number of display colors and resolution may affect the screen. Restart the 
computer.
  Connecting/disconnecting an external display may affect the screen. Restart the com-
puter.
During Simultaneous display, 
one of the screens becomes 
disordered.
  When using the Extended Desktop, use the same display colors for the external display 
as those used by the LCD.
  If you continue to experience problems, try changing the display.
Click 
 (Start) - [All Programs] - [Panasonic] - [Display Selector].
  Simultaneous display cannot be used until Windows startup is complete (during Setup 
Utility, etc.).
The external display does 
not work normally.
  If the external display does not support the power saving function, it may not work nor-
mally when the computer enters the power saving mode. Turn off the external display.
<Only for model with GPS>
The cursor cannot be con-
trolled properly.
  Operate the following steps.
A
   Restart the computer and press 
F2
 or 
Del
 while [Panasonic] boot screen is dis-
played.
B
   Set [GPS] to [Disable] in the sub-menu of [Serial and Parallel Port Settings] in the 
[Advanced] menu of the Setup Utility.
C
   Press
 
F10
 and select [Yes] at the confi rmation message, and press 
Enter
.
The computer will restart.
D
   Log on to Windows as an administrator.
E
   Click 
 (Start) and input “c:\util\drivers\gps\GPS.reg” in [Search programs and 
fi les], and press 
Enter
.
F
   Click [Yes], click [Yes], and click [OK]. 
Then restart the computer.
G
   Press 
F2
 while [Panasonic] boot screen is displayed.
H
   Set [GPS] to [Enable] in the sub-menu of [Serial and Parallel Port Settings] in the 
[Advanced] menu.
I
   Press 
F10
 and select [Yes] at the confi rmation message, and press 
Enter
.