Barco R9828832 Manuale Utente
Chapter 9
Trouble Shooting
Daylight Display Systems
127
BARCO DLite Software
Initial Tile Setup / Guided setup
RS232-SWITCH NOT OPEN
Check the communication port settings: port number, baudrate,
Make sure the selected serial port isnt currently in use by another program
Check whether the RS232 cable is intact and plugged in right
If the line-up includes the Fiberlink, Check the power connections to the Fiberlink transmitter and receiver
Make sure the selected serial port isnt currently in use by another program
Check whether the RS232 cable is intact and plugged in right
If the line-up includes the Fiberlink, Check the power connections to the Fiberlink transmitter and receiver
and Check if it is not powered off.
If the line-up includes the Fiberlink, Check the messages on the display of the Fiberlink transmitter to see if
If the line-up includes the Fiberlink, Check the messages on the display of the Fiberlink transmitter to see if
there arent any errors in the Fiberlink connection
FAILED TO DETECT RESOLUTION ID
Each tile must have an internal id unique for each type of tile. This is missing or corrupt.
Contact your vendor.
Contact your vendor.
DURING INITIAL TILE SETUP THE VIDEO GETS ALL SCRAMBLED UP
Check whether the start position and direction of the link correspond with the way the tiles are linked
together
FAILURE DURING ADDRESSING: TILE ADDRESSING DOESNT REACH THE
SET UP NUMBER OF TILES IN THE WALL
Each one of the tiles could be responsible for not sending a response back to the digitizer. Each tile should
be controlled and not only the last tile.