Benq MP525 ST Manuale Utente

Operation

Setting the User 1/User 2 mode

There are two user-definable modes if the current available picture modes are not

suitable for your need. You can use one of the picture modes (except the User 1/2) as a

starting point and customize the settings.

Press Menu/Exit to open the On-Screen Display (OSD) menu.

Go to the PICTURE > Picture Mode menu.

Press

to select User 1 or User 2.

Press

to highlight Reference Mode.

This function is only available when User 1 or User 2 mode is selected up in the Picture Mode
sub-menu item.

Press

/ to select a picture mode that is closest to your need.

Press to select a menu item to be changed and adjust the value with

. See

below for details.

When all settings have been done, highlight Save Settings and press Mode/Enter to
store the settings.

The confirmation message "Setting Saved" displays.

Fine-tuning the image quality in user modes

According to the detected signal type, there are some user-definable functions available

when User 1 or User 2 is selected. Based on your needs, you can make adjustments to

these functions by highlighting them and pressing

on the projector or remote

control.

Adjusting Brightness

The higher the value, the brighter the image. And the

lower the setting, the darker the image. Adjust this

control so the black areas of the image appear just as

black and that detail in the dark areas is visible.

Adjusting Contrast

The higher the value, the greater the contrast. Use this

to set the peak white level after you have previously

adjusted the Brightness setting to suit your selected

input and viewing environment.

-30