American Dynamics KT-MOD-CAB Dépliant

 

Telephone: 1 (450) 444-2030 

• Toll free: 1-888-222-1560 • Fax: 1 (450) 444-2029 • Internet: 

www.kantech.com

 

 

 

Copyright © 2008 Tyco International Ltd. and its Respective Companies. All Rights Reserved • Specifications may change without notice. 

Kantech and the Kantech logo are trademarks of Tyco International Ltd. and its Respective Companies. 

2

E

XPANSION 

M

ODULES 

C

ABINET 

I

NSTALL 

S

HEET

DN1806-0809 

 

5.  Run a 41 cm (16 in) SPI cable, provided with 

every module, between the other modules. 

6.   If external power is required for the expansion 

modules, run the ground and power cables 
together through a separate knockout than 
in Step 4. Connect the external power supply 
to the expansion module as per their 
corresponding install sheet. 

7.   Check the external power jumper position on 

the expansion modules. 

8.   Run and connect the inputs or outputs 

together through a separate knockout than 
in Step 6 to each expansion module as per 
the corresponding install sheet. 

Note: Make sure that you don’t exceed the 
conduits capacity according to the 
specifications and the local building code. 

9.   Install and connect the tamper switch to the 

tamper switch terminals on the KT-400 
controller. 

10.  Power up all the expansion modules and verify 

communication with the KT-400 controller. 

11.  Install the cabinet door.