American Dynamics KT-MOD-INP16 Manuale Utente

 

• Toll Free: 1-888-222-1560 • Fax: 1 (450) 444 2029 • Internet: www.kantech.com

Copyright © 2008 Tyco International Ltd. and its Respective Companies. All Rights Reserved. 

• Specifications may change without notice. 

Kantech and the Kantech logo are trademarks of Tyco International Ltd. and its Respective Companies. 

KT-400 Expansion Module 16-Zone Input with SPI Cable Install Sheet

CAUTION: Changes or modifications not expressly approved by Kantech could void your authority to use this equipment. 
This equipment generates and uses radio frequency energy and if not installed and used properly, in strict accordance with the manufacturer’s instructions, 

may cause interference to radio and television reception. It has been type tested and found to comply with the limits for Class A device in accordance with 

the specifications of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in any residential installation. 

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to television or radio 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 
• 

Re-orient the receiving antenna 

• 

Relocate the alarm control with respect to the receiver 

• 

Move the alarm control away from the receiver 

• 

Connect the alarm control into a different outlet so that alarm control and receiver are on different circuits. 

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may find the following 

booklet prepared by the FCC helpful: “How to Identify and Resolve Radio/Television Interference Problems”. This booklet is available from the U.S. 

Government Printing Office, Washington, D.C. 20402, Stock # 004-000-00345-4. This device complies with Part 15 of the FCC rules. Operation is subject to 

the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including 

interference that may cause undesired operation. This Class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment 

Regulations. The KT-400 is also compliant with EN55022: 1994, amendment 1: 1995, Class A.