Compaq Infortrend Manuale Utente
Fibre Operation
8-21
1.
Host HBA port name (WWPN) list:
Host A = 0x…F111
Host A = 0x…F111
Host B = 0x…F112
Host C = 0x…F222
Host C = 0x…F222
2.
Controller Configuration:
•
Logical drives are LD0 and LD1. LD0 is partitioned into two:
P0 and P1.
P0 and P1.
•
Filter Entry (LUN map) list
Configuration Procedure:
1.
Create an entry list for the specific logical unit from "View and
Edit Host LUN"\Host Channel\Create Host Filter Entry."
Edit Host LUN"\Host Channel\Create Host Filter Entry."
2.
Select Host Channel ID, and then select a configured logical unit
(a logical drive, logical volume, or one of its logical partitions) to
create the entry. The entry submenu will appear.
(a logical drive, logical volume, or one of its logical partitions) to
create the entry. The entry submenu will appear.
3.
Enter and modify the Host ID, Host ID Mask, Filter Type, and
Access Mode.
Access Mode.
The exemplary entry list is shown below. Please refer to the
diagram above:
diagram above:
Entry 1: "LD0-P0, ID=0x…F111, Mask=0x…FFFE, Filter Type =
Include, Access Mode = Read/Write." It means Host A
and B can read/write P0 of LD0.
and B can read/write P0 of LD0.
Entry 2: "LD0-P1, ID=0x…F222, Mask=0x…FFFF, Filter Type =
Exclude, Access Mode = Read/Write." It means Host A
and B can read/write P1 of LD0, but this partition is
inaccessible for Host C.
and B can read/write P1 of LD0, but this partition is
inaccessible for Host C.