Compaq Infortrend Manuale Utente
Infortrend
9-19
IMPORTANT!
•
If the drives are configured as “Delay Motor Spin-up” or “Motor Spin-up
in Random Sequence,” some of these drives may not be ready at the moment
when the controller accesses them when powered up. Increase the disk
access delay time so that the controller will wait a longer time for the drives
to be ready.
SCSI Reset at Power-Up
By default, when the controller is powered up, it will send a SCSI
bus reset command to the SCSI bus. When disabled, it will not send
a SCSI bus reset command on the next power-up.
bus reset command to the SCSI bus. When disabled, it will not send
a SCSI bus reset command on the next power-up.
When connecting more than one host computer to the same SCSI
bus, the SCSI bus reset will interrupt all the read/write requests that
are being delivered. This may cause some operating systems or host
computers to act abnormally. Disable the “SCSI Reset at Power-up”
to avoid this situation.
bus, the SCSI bus reset will interrupt all the read/write requests that
are being delivered. This may cause some operating systems or host
computers to act abnormally. Disable the “SCSI Reset at Power-up”
to avoid this situation.
Choose “SCSI Reset at Power-Up”, then press [ENTER]. Choose Yes
in the dialog box that follows to confirm the setting.
in the dialog box that follows to confirm the setting.