Compaq Infortrend Manuale Utente

To create a logical drive, press ENT for
two seconds to enter the Main Menu.
Use  ▼ or ▲ to navigate through the
menus.  Choose "View and Edit Logical
Drives," and then press ENT.

Press  ▼ or ▲ to select a logical drive
entry, then press ENT for two seconds
to proceed.  "LG" is short for Logical
Drive.

Press  ▼ or ▲ to choose the desired
RAID level, then press ENT for two
seconds. "TDRV" (Total Drives) refers
to the number of available SCSI drives.

Press ENT for two seconds, a message,
“RAID X selected To Select drives”,
will prompt.  Confirm your selection
by pressing ENT.

Press ENT, then use ▼ or ▲ to browse
through the available drives.  Press
ENT again to select/deselect the
drives. An asterisk (*) mark will appear
on the selected drive(s).  To deselect a
drive, press ENT again on the selected
drive.  The (*) mark will disappear.
"C=1 I=0" refers to "Channel 1, SCSI ID
0".

After all the desired drives have been
selected, press ENT for two seconds to
continue.  Press ▼ or ▲ to choose
“Create Logical Drive,” then press
ENT  for two seconds to start
initializing the logical drive.

You may also choose “Change Logical
Drive Parameter,” then press ENT to
change related parameters before
initializing the logical drive.

View and Edit
Logical Drives

LG=0
Not Defined    ?

TDRV=4 Create
LG Level=RAID5 ?

C=1 I=0   1010MB
NEW DRV  SEAGATE

Create Logical
Drive          ?

Change Logical
Drive Parameter?

RAID X  Selected
To Select drives