Compaq Infortrend Manuale Utente

Infortrend

5-29

Its current status will be displayed on
the LCD. Press ENT to continue.

Press ENT again for two seconds to
change the terminator mode to the
alternate setting.

IMPORTANT!

•

You can use terminator jumpers on the controller board to control SCSI

bus termination of the SentinelRAID series controllers. When using

jumpers to control, firmware termination setting must be disabled. To

disable SCSI termination of a SCSI bus, the associated terminator jumpers

must be left open, and firmware setting must be disabled.

Setting Transfer Speed

Transfer speed refers to the SCSI bus speed in synchronous mode.
Asynchronous mode is also available in this option setting. In
Ultra/Ultra Wide SCSI, the maximum synchronous speed is
20.8Mhz.

Press ENT for two seconds to enter the
Main Menu. Press ▼ or ▲ to select
"View and Edit SCSI Channels," then
press ENT.

Channel information will be displayed.
Press ▼ or ▲ to select a channel. Press
ENT on the channel you wish the
transfer speed changed.

Press ▼ or ▲ to select “Set Transfer
Speed," then press ENT.

The current speed of this SCSI channel
will be displayed. Press ▼ or ▲ to
select the desired speed, then press
ENT for two seconds to confirm.

IMPORTANT!

•

Every time you change the Transfer Speed, you must reset the controller
for the changes to take effect.

View and Edit
SCSI Channels

↕

CH0=Host PID=0
SID=NA SXF=80.0M

Set Transfer
Speed ..

SCSI Terminator
Enabled ..

CHL=0 Clk=80.0M
Change to=40.0M?

CHL=0 Disable
Terminator ?