Cisco Systems 274 Manuale Utente
5-13
Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
OL-17739-01
Chapter 5 Troubleshooting the System Hardware
Power-On Self Test (POST)
Note
A single problem might cause several error messages. When this situation occurs,
you should correct the cause of the first error message. After you correct the cause
of the first error message, the other error messages usually will not occur the next
time that you run the test.
you should correct the cause of the first error message. After you correct the cause
of the first error message, the other error messages usually will not occur the next
time that you run the test.
POST Numeric Codes and Text Messages
This section covers POST errors that have numeric codes associated with them.
The section also includes some text messages that may be encountered during
POST.
The section also includes some text messages that may be encountered during
POST.
Note
The computer will beep once after a POST text message is displayed on the
screen.
screen.
Table 5-10
Diagnostic Front Panel LEDs and Beep Codes
Control Panel Message
Description
101-Option ROM Checksum Error
System ROM or expansion board option ROM
checksum.
checksum.
103-System Board Failure
DMA or timers.
110-Out of Memory Space for Option ROMs
Recently added PCI expansion card contains an
option ROM too large to download during POST.
option ROM too large to download during POST.
162-System Options Not Set
Configuration incorrect.
RTC (real-time clock) battery may need to be
replaced.
replaced.
163-Time & Date Not Set
Invalid time or date in configuration memory.
The RTC (real-time clock) battery may need to be
replaced.
replaced.
163-Time & Date Not Set
CMOS jumper may not be properly installed.
164-Memory Size Error
Memory amount has changed since the last boot
(memory added or removed).
(memory added or removed).
164-Memory Size Error
Memory configuration incorrect.