Chief Manufacturing CTA-100 Manuale Utente

Installation Instructions 

CTA-100 

 

 

9

 

 

 
 
Stacking Two Units 

Stack two units, as follows: 

1.  Locate the top attachment plate (10) for the second 

unit. 

The stacked load cannot exceed 50lbs. (22.7kg). 

2.  Install the second attachment plate (10) on the center 

plate (20) of the first CTA-100 unit. Use four flat 
washers (70) and four M5 X 8mm button head cap 
screws (60). Tighten the screws. See Figure 9. 

3.  Attach the second CTA-100 to the second attachment 

plate (10). Use four flat washers (70), four M5 X 8mm 
button head cap screws (60). Tighten the screws. 

4.  Install your VCR/DVD into the CTA-100. 

5.  Adjust the side plates (30) and adjustment plates (40) 

as needed to secure your VCR/DVD safely in the 
CTA-100. 

 

 

6.  Tighten all cap screws (60). 

Failure to install and tighten the screws to secure your 
VCR/DVD can result in personal injury and/or 
equipment damage.  

7.  Check the CTA-100 to ensure that the side plates (30) 

and adjustment plates (40) are adjusted correctly. The 
unit should fit tightly around your VCR/DVD. If not, 
repeat steps 5 and 6 until your VCR/DVD is secure. 

 

Stack three units, as follows: 

1.  Perform the “Stacking Two Units” procedure to install 

the third CTA-100. 

Do not stack more than three VCR/DVD mounts from 
a TV/Monitor mount. The stacked load cannot exceed 
50lbs. (22.7kg). 

2.  Verify that all three units are secure. 

(70) 

(80) 

(10)