Cabletron Systems FOT-F3 Manuale Utente
Page 1 - 2
INTRODUCTION
Chapter 2, Installation Requirements/Specifications,
contains a list of hardware, software, location and
environmental requirements that must be met before you
install the FOT-F3. A list of FOT-F3 specifications is also
provided.
contains a list of hardware, software, location and
environmental requirements that must be met before you
install the FOT-F3. A list of FOT-F3 specifications is also
provided.
Chapter 3, Installing the FOT-F3, contains steps for
unpacking the FOT-F3, setting the SQE switch,
connecting the transceiver to the network, connecting the
transceiver to an active Ethernet device, and, if desired,
mounting the transceiver with the Velcro
unpacking the FOT-F3, setting the SQE switch,
connecting the transceiver to the network, connecting the
transceiver to an active Ethernet device, and, if desired,
mounting the transceiver with the Velcro
mounts provided
with the unit.
Chapter 4, Testing and Troubleshooting, contains
procedures for verifying the proper installation of the
FOT-F3. It also describes LANVIEW
procedures for verifying the proper installation of the
FOT-F3. It also describes LANVIEW
LEDs and their
function.
You should have a general working knowledge of Ethernet
or IEEE 802.3 type data communications networks and
their physical layer components before installing the
FOT-F3.
or IEEE 802.3 type data communications networks and
their physical layer components before installing the
FOT-F3.
1.2 GETTING HELP
If additional support is needed related to the Cabletron
Systems FOT-F3, or if you have any comments,
improvements, suggestions, or questions relating to this
Systems FOT-F3, or if you have any comments,
improvements, suggestions, or questions relating to this