3com 3C319 Manuale Utente

C

HAPTER

 5: C

ONFIGURING

 

THE

 NIC M

ANUALLY

To configure the 3C319 NIC, the NIC must be already 
installed in your PC and connected to the network, as 
described in 

The Configuration and Diagnostic Program is a DOS 
application that will not function properly if the 3C319 
drivers are already installed. 

The Configuration and Diagnostic Program indicates 
memory conflicts if you run it with a memory manager 
without excluding the memory range used by the 
3C319 NIC. Before you run the Configuration and 
Diagnostic Program, you must bypass the drivers and 
the /memory manager. Use a DOS diskette if you are 
running DOS 5.0 or earlier.

If you are running Windows NT, perform a clean boot 
from the DOS partition, or boot from a DOS diskette to 
run the diagnostic program. If you use Windows 95 or 
Windows for Workgroups, exit Windows and restart the 
PC in MS-DOS mode, or boot from a floppy that has the 
operating system installed on it.

Before starting, make sure that you have performed 
a clean DOS boot according to the instructions in the 
preceding section, 

.” To configure the 3C319 NIC in a PC 

without PnP support, follow these steps:

1 Insert TokenDisk diskette #1 in a floppy drive (for 

The first time you use the installation software, a 
software license screen appears.