Samsung RIF-BT10 Manuale Utente

                                                     

      

 
 

15

  1) Bluetooth address  

    - Individual address of each Bluetooth module. 

  2) Firmware version 

    - Bluetooth firmware version. 

    3) Role 

    - Selection of Master/Slave. 

  4) Baud rate 

    - Transmission speed setting. 

  5) Flow control 

    - Handshaking condition setting. 

    6) Auto connect to printers 

        - Auto connection to the designated Bluetooth slave. 

    - Applicable when the designated printer (Bluetooth slave) used. 

        - When the multiple printers installed, simultaneous printing becomes available. 

        - It ignores the printer in Power off mode.   

        - The data transmission stands by when any of the registered printers goes on Busy mode such 

as no paper, cover open, buffer full etc until it recovers.   

        - With no use of this option, Application program should send data only after it connected to 

Bluetooth slave by Control message. This can be used when wanted to use the designated 

one out of several printers   

    7) Wait for all connected 

        - It is available only when Auto connect to printers selected. 

    - Under the condition of several Bluetooth slave saved in Bluetooth master, it transmits the data 

thoroughly until the all the registered printers complete the reception.     

  8) Printer name 

        - You can set the printer name less than 15 letters. 

                    9) Auto detect 

                        - It is to read the individual printer name such as SRP-350 etc. 

                        - It is available only when the printer has the individual name. 

                    10) Printer location 

            - It is to set the location identity of the printer such as Kitchen PRT 1 or Receipt PRT 1 less 

than 12 letters.   

                    11) Print F/W info 

                        - Printer prints the firmware data of Bluetooth slave module at printer power on.