8e6 Technologies ER3-200 (5K02-56) Manuale Utente

6

8

e

6 e

nterprise

r

eporter

Q

uick

s

tart

G

uide

6

8

e

6 e

nterprise

r

eporter

Q

uick

s

tart

G

uide

a

ppendix

: san i

nstallation

D.  Plug the other end of the CAT-5E crossover cable into the storage device’s port “0” 

(zero) on the right (see Figure 3 Item B).

E.  Plug the storage device’s AC power cords into the back of the unit (see Figure 3 Item 

C).

F.  Plug the loose ends of the AC power cords into a power source with an appropriate 

rating. It is strongly suggested you use an uninterruptible power supply.

WARNING: Be sure all drives are installed in the storage device unit before 

G.  Turn on the power switches at the back of the storage device, 

which are positioned to the right of the power cord connectors. 

The boot-up process may take up to 5 minutes. When the unit 

is booted up, the three vertical LED lights at the left of the front 

panel will be lit up (see Figure 4). 

      Once all LED lights are lit, the ER can be powered on. 

      Follow the procedures in this section if you need to shut down or 

restart the storage device.

      If you need to shut down the storage device, always follow these 

steps:

A.  Power off the ER unit first. (Refer to the Physically Connect the ER to the Network 

sub-step in Step 1B of the ER section for shut down procedures.)

B.  Power off the storage device next by turning off both switches in the back of the unit.

The storage device must be restarted after a power failure. In this instance, the storage 

device may already be turned on, but needs to be booted up again.

WARNING: You must always power on the storage device before powering on 

To restart the storage device, press the power button on the front panel. The boot-up 

process may take up to 5 minutes.