Silex Technology SX-600 Manuale Utente

 

19

 
Information for United States Users 
This equipment has been tested and found to comply within the limits for a Class B digital device 
pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable 
protection against harmful interference in a residential installation.  This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications.  However, there is no 
guarantee that interference will not occur in a particular installation.  If this equipment does cause 
harmful interference to radio and television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one or more of 
the following measures: 
 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver, 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

Consult the dealer or an experienced radio/TV technician for help. 

 
The user is cautioned that changes and modifications made to the equipment without the 
approval of manufacturer could void the user’s authority to operate this equipment. 
 
Operation is subject to the following two conditions:  (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that 
may cause undesired operation. 
 
The radiated output power of the print server is far below the FCC radio frequency exposure 
limits. Nevertheless, print server shall be used in such a manner that the potential for human 
contact during normal operation is minimized. 
 
To satisfy RF exposure requirements, this device and its antenna(s) must operate with a 
separation distance of at least 20 centimeters from all persons and must not be co-located or 
operating in conjunction with any other antenna or transmitter.  End-users must be provided with 
specific operating instructions for satisfying RF exposure compliance.